The Armanov PRO Case Feeder Plate is an evolution of all the casefeeder plate solutions on the market. The result is a thicker grooved casefeeder plate with 36 pockets that maximizes output of the casefeeder. The pockets can accept cases from .380 to .45 making the PRO Plate able to feed most pistol calibers on the market in one UNIVERSAL solution. The plate thickness helps to give the cases some directional support when sliding out of the plate, making them less prone to get jammed in the output funnel.

If reloading longer revolver cases (38SPL and 357) we recommend running the plate in lower speeds and in combination with a washer spacer to elevate the plate. NOT .44MAG RECOMMENDED FOR USE WITH .44Mag.

From our testing we found that original plates tend to drag on the bottom of the case feeder when filled with cases. A faster plate makes this worse because its efficiency invites you to load even more cases into the feeder. The PRO Plate solves this with a ball bearing ring that delivers smooth rotation no matter the case load and reduces strain on the motor. All this allows the PRO Plate to raise case output by 30-80% compared to the original (depending in the plate and caliber).

The plate thickness helps to give the pistol cases some directional support when sliding into the chute, making them less prone to get jammed in the output funnel. On the Rifle plates this thick center allows the cases to roll to the pocket easier minimizes empty pockets passing the output chute.

Like the original plate all PRO Plates feature a slip disc or clutch in the centre to allow the motor to continue spinning if a case gets jammed. To make plate changeover easier they also have a built in folding handle in the center.

All PRO Plates com with a dislodging wedge that reaches down under the plate, minimizing the chance of a case getting stuck or jammed like with the original Dillon wedge. ONLY NEDED FOR VARIABLE SPEED CASEFEEDER, OLDER METAL SHROUD CASEFEEDERS DO NOT NEED THE WEDGE.